-
FREE MEMBER
NO Posting or PM's Allowed
Type 1 rear sight - real or repro?
Any thoughts on the authenticity of this rear sight?
Attachment 47463Attachment 47464Attachment 47465Attachment 47466Attachment 47467Attachment 47468
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
11-27-2013 01:05 AM
# ADS
Friends and Sponsors
-
Senior Moderator
(Milsurp Forums)
I believe this to be real. However, there are a few guys here who can glance at these and be able to tell better than I.
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
-
-
Legacy Member
That one is a tough call for me. If it is a fake, its a darn good one. Milling looks correct.
When they tell you to behave, they always forget to specify whether to behave well or badly!
-
-
As Jim mentions, tough call. I have vertical milling marks like those shown on the side of some of my leafs. The edges of the base seem a bit more rounded. And the spring appears to be newer.
-
Thank You to JimF4M1s (Deceased) For This Useful Post:
-
Legacy Member
The base is suspect, I'm with Jim, if it's fake it is a good one. Base looks too rounded.
-
Thank You to Rustship For This Useful Post:
-
Advisory Panel
Is it possible that it's been a put together? Fake base but real top? That way most people would look at the machine marks and go for it?
-
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks all for the input. The "similar threads" tool here is also extremely helpful. The journey continues.
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks.
Next batch I make will be perfect and a steal at $125 a pop.
-
Senior Moderator
(Milsurp Forums)
ChipS, you're bad!
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-