No.4Mk1* wood, will it fit?

[Oatmeal Savage]

Will No.4Mk1* wood fit a No.4Mk.2 Enfield? I have a mark 2 but I can't find wood for it, so could I use the Mk.1 stock and just remove the wee partition at the back of the bottom forestock? Is it that simple?

Thanks
OS

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[stencollector]

That has been done many times before. The only real problem will be that the tie plate in the back must be cut in half, or altogether removed and the areas filled. If you have the sporterised mk2 stock, you can transfer the rear hardware accross.
Of course, you may also have to properly bed the rifle action in to the stock. The muzzle of the barrel should rest firmly in the bottom of the front of the forestock, with a pulloff of about 3-6 pounds. If lifted up and right or left, it should go back down to the center.

[Oatmeal Savage]

Thanks, stencollector! I have a bubba'd stock to use parts from.

OS

[Claven2]

Easier just ot watch e-bay for a Mk2 stock - they are out there.

[Cantom]

Easier just ot watch e-bay for a Mk2 stock - they are out there.

Easier yet to read this link
http://www.e-gunparts.com/product.as...SKU=903070&MC=

and call Numrich, ask for the international order lady and order it. I've recently looked into one of those for my No 4 Mk 2.

[woodchopper]

Easier yet to read this link
http://www.e-gunparts.com/product.as...SKU=903070&MC=

and call Numrich, ask for the international order lady and order it. I've recently looked into one of those for my No 4 Mk 2.

Renada @ (845) 679-3520

and keep your orders under $100

[Cantom]

Renada @ (845) 679-3520

and keep your orders under $100

I ordered over $100 with no issues...they only care if you order something they're not allowed to ship without licences, like barrel/bolt/slide/receiver.

I think she said up to $500 was okay.

[woodchopper]

I ordered over $100 with no issues...they only care if you order something they're not allowed to ship without licences, like barrel/bolt/slide/receiver.

I think she said up to $500 was okay.

yes I understand that they just changed the rules


I placed an order myself 2 days ago

[Oatmeal Savage]

I received the No4 stock and it is a Mk.1 stock. I will leave the stock that is on the Mk.2 in place. I can't bring myself to cut the Mk.1 stock to fit the Mk.2. I will wait until a Mk.2 stock comes along. I also received a Mk.1 stock from Numrich, it is brand new, I had to trim the butt stock and the fore stock to fit.

[sdh1911]

When it comes to wood fit. The tension allpied on the wood north of the reciever had a direct impact on accuracy. You may wish to find the spec. as defined by the maker (Enfield) and groom the wood to fit the standard set by them.HTH-SDH