This revolver was giving me light primer strikes in Double Action. I installed a Cylinder and Slide .002 end shake bearing and now it will fire 5 rounds DA then it will not fire DA until I fire one round SA. Once I do fire SA it will fire again. It does this with both factory loads and reloads are are more or less duplicates of factory. It also does this with a variety of moon and half moon clips.

I've also installed a new wolf main spring and put a shim (fired primer) over the set screw.

Anyone got thoughts on this?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.