-
FREE MEMBER
NO Posting or PM's Allowed
Another Bedding Job Question
When to do the finish on the stock set ?
I'm going to use the NM stock set that CMP offers because of being inletted already. My question is should the glassing be done before I finish the stock set, i.e. oil it -OR- do my staining and oiling before doing the bedding ?
Thanks again
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-31-2009 08:28 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
I am in the process of bedding my Garand and I would wait until you have it bedded before doing your stock work. No matter how hard you try to keep the bedding compound off you stock-it's like herding cats-it will run. My stock was previously finished and I will have to refinish most of the area where the wood and metal meet. This was after I taped the stock with painters "blue" tape. Good luck and one word of advice, before you glue anything together do a dry run and make sure you have everything you need
-
-
FREE MEMBER
NO Posting or PM's Allowed
Sir, it's a question of whether you prefer to mask the finish while bedding or mask the bedding while finishing. Having done it both ways, I now prefer to finish before bedding.
JMHO, FWIW.
Hope this helps, and Semper Fi.
Ron H.
-
FREE MEMBER
NO Posting or PM's Allowed
My last bedding (CMP NM stock) I masked, did the bedding, then finished the wood. My reasoning (perhaps flawed) was I wanted the best possible bond of the bedding material to the wood possible. I didn't want BLO/Tung etc to be between the bedding material and the wood.