-
FREE MEMBER
NO Posting or PM's Allowed
opinion on my 5.58 HRA
Maybe ten years back I bought a service grade of every manufacturer,when they first anounced you could pick manufacturer. I was looking at my HRA 5.58 million. LMR barrel I think is correct, 3/8 DAS stock I might have swapped off another M1.Stacking swivel screw appears to be staked by mushrooming the the end of the screw. Of note is that the muzzle crown is set deep is this typical of LMR barrels? I think all over parts are HRA stamped. Do these parts sound OK for the serial range?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Last edited by Curt; 12-23-2009 at 05:30 PM.
-
12-23-2009 05:19 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
I believe LMR barrels are found throughout HRA production.
The 3/8 DAS seems a little early but some original late rifles may have been found with them. IHCFAN (Wayne) would be a great resource on this.
Merry Christmas!
-
-
FREE MEMBER
NO Posting or PM's Allowed
When I had finished buying I did some parts swapping, and then bought a few items to finish the HRA and IHC. I decided this winter to spend a little time with the Garands.