-
FREE MEMBER
NO Posting or PM's Allowed
BBL receivers report
Well, I got them today finally ( I can't exactly remember when I ordered them). They were as advertised but a bargain. One was a 3.7 million with a 5-45 barrel 3/16" bullet test on muzzle, TE 3. The other is a 722xxx with a 7-42 barrel that is shot out so bad that when I run a patch down it it doesn't even spin it just goes straight. Both bbls are rusty inside but the '45 bbl will eventually be shootable I'm sure; the other ... not so much. No chrome on either. The bad bbl has 7.62 stamped on top under the handguard area but takes an '06 cartridge just fine. I wonder what's up with that? The finish on both is mostly 80% or better but there is pitting at the wood contact areas here and there. All in all I'm pleased with my purchase and will post pics in the next day or so. Steve
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-12-2009 03:31 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
I have seen the "7.62" stamping on the top of the barrel on some CMP barreled receivers. I think it just indicates that it is 30 cal. and not 7.62 x 51.
-
-
FREE MEMBER
NO Posting or PM's Allowed
Sounds like you did okay given the money spent. We look forward to your pictures.