-
FREE MEMBER
NO Posting or PM's Allowed
cast lead bullets for M1 carbines?
Can a person reload .30 carbine ammo with cast lead bullets? Do those work OK in the rifles? I've found a source for 115gr. LRN's, so I've gotta ask. I just use the carbine for target shooting and plinking.
Many thanks!
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
11-18-2009 07:31 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Yep!
Don
-
-
Advisory Panel
I used nothing but cast bullets for carbine for years. I had no source of jackets so that was that. They work just fine.
-
-
Legacy Member
Yes
YES!
Cast are fine, cast with gas checks are gooder!
“Any society that would give up a little liberty to gain a little security will deserve neither and lose both.”- Benjamin Franklin
-
-
FREE MEMBER
NO Posting or PM's Allowed
Cast in the 30 Carbine
The answer to your question is a definite yes! A 115 grain LRN is in the weight ballpark. The use of gas checks is recommended. Round noses feed more reliably/best. Keep your cases trimmed uniformly to the proper or recommended length. Use a slight taper crimp, but not too much as the round must seat on the case mouth. There are several powders that work well. You can check in a loading manual, or do a search on previous threads/posts on this forum for additional info. I use 13.5 grains of IMR 4227 and get reliable cycling of the action, good feeding and really decent accuracy....and at considerable savings over store or anywhere-else bought ammo. If you full length resize your cases even with a carbide die make sure to lube at least every 3 rd case as it makes the job easier, is better for the cases and the die. I cast my own and that dramatically reduces even more the cost of making the ammo. For some folks, that may be an out of budget investment and or a PITA chore workwise, but if one does a lot of shooting it may well be worthwhile to look into. Good luck and good shooting. JC
-
Legacy Member
14.5 grains of WW296 works well in my rifle.
-