Which Underwood trig housing is correct?

[colreed]

Am confused by Reisch about which .U. trig housing should be on my Underwood SN 4,042,813. The one I have is a type IV stamped/braised. But should it be a type III?
Any help would be appreciated.
Thanks

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[painter777]

Colreed,
I have Underwood 4,054,680 in original condition...but with the rear sight swapped out to a adj type II. My housing is Brazed/Stamed type IV. I would think either a type III or IV could be very possible as issued.

HTH
Charlie-painter777

[colreed]

I noticed at the bottom of your post reply to me, there is a button for PM, which I assume is for someone to send you an Email instead of a post reply. I've looked and looked but can't figure how to activate that. I'd like to give members the opportunity to email me from a post I made rather than reply. Can you tell me how to get my setup to allow that?
Thanks again.
Reed

[painter777]

I noticed at the bottom of your post reply to me, there is a button for PM, which I assume is for someone to send you an Email instead of a post reply. I've looked and looked but can't figure how to activate that. I'd like to give members the opportunity to email me from a post I made rather than reply. Can you tell me how to get my setup to allow that?
Thanks again.
Reed

Go to your Personal Control Panel....
Click on the "Edit Options"
Then find the "Messaging and Notification" section...
Here you can set up your changes.

I think I helped

Charlie-painter777

[colreed]

Thanks again Charlie
Found "messenging" but not "messaging and notification". Still working on it.
This is going to take some getting used to. Too fancy!

[painter777]

You have to go into your profile, where you set up your Avatar pic and allow PM's to me sent.
I think....still trying to work the bugs out myself.

Charlie-painter777

[Harlan (Deceased)]

You have to go into your profile, where you set up your Avatar pic and allow PM's to me sent.
I think....still trying to work the bugs out myself.

Charlie-painter777

Thanks Charlie,
I set mine up to accept email and just tested it successfully.
(WITH AOL!) - Email was here in seconds.

I hope everyone will set theirs up to accept email.

[Bruce McAskill]

ColReed, The type 4 trigger housing would be correct for your serial number.

[colreed]

Thank you Bruce. Good news.

[lboos]

Harlan, I still cant fix it? I went to per. cont. panel, eddit opt., mesg./ notice and X the accept email, and clk. on save changes? should i have clk. on reset fields?
I think im getting to old to learn new trick's, any advice?