-
Advisory Panel
New 9MM
This one was built a little bit back, after I had a 5" HK type barrel upper...tried it and thought it was too short. This one is 8 1/4" bbl and 9mm, uses the hammer that a normal rifle would(for those of you that understand that part). It has a spacer added inside the lower receiver extension so the bolt won't come back so far and shear off the bolt catch on an empty mag. The bolt for these is quite heavy by comparison if you've never handled one. There's a tungsten slug installed in the rear... The front tube is an NEA and the little front hook is quite comfortable for a front grip. It drops in between fingers...
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
The Following 4 Members Say Thank You to browningautorifle For This Useful Post:
-
07-06-2017 11:48 PM
# ADS
Friends and Sponsors
-
Legacy Member
That would be a fun Pew Pew, looks cool too.
-
Thank You to WarPig1976 For This Useful Post:
-
-
Advisory Panel
I wonder where this stuff was 40 years ago when we could have used it? Mind, the Sterling offshoot we used served just fine.
-
-
Legacy Member
-
Thank You to imarangemaster For This Useful Post:
-
Advisory Panel
Wish you were closer, we'd just take it out and warm it up a bit...
-
Thank You to browningautorifle For This Useful Post: