-
douglass
Guest
Ross M1910 Screw names
Ross M1910 Stock and trigger guard screws
Hi all
Looking for a stock screw and see numrich has them but cannot find a trigger guard screw listed, is there another name for them??
its just that the 2 screws on my Ross M1910 have had the screw head almost ruined by the previous seller suing a wrong sized screwdriver
would appreciate any more info/advice etc etc
regards from Scotland
Douglass
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-23-2011 04:08 PM
# ADS
Friends and Sponsors
-
Contributing Member
Front and rear action screws.
-
-
-
douglass
Guest
Hi there
thanks for that
regards
douglass
-
-
Contributing Member
-
-
Advisory Panel
There is a fair bit of meat on those screws, which means that they can be cleaned up wi' a file and the slots deepened with a hacksaw. Saves buying new ones.
Ross threads are 60-degree V-type, US standard. Anyone with a lathe should be able to cut them, knowing that.
Good luck.
.
-