-
FREE MEMBER
NO Posting or PM's Allowed
Garand gunsmith in Panama City area
Does anybody know of a decent gunsmith that can re-index the barrel on my M1 Frankengarand? I'm capable of doing the work, but don't want to buy/build the tools.
Thanks.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
02-15-2011 07:13 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
too bad you are not in texas, with that said. If the barrel is going past the 12 oclock postion, you will need to find a smith with a roll swage tool to swage the torque shoulder. If you cant get to 12 oclock the torque shoulder must be trimmed a bit, from your comment it sounds like your barrel is going past the 12 oclock postion. is that a used barrel ? or a short chambered new barrel ? after you get that done make sure as you know to ck headspace and bolt release timing and that garand should run flawless with good ammo. oh and sorry i dont know anybody in Fl..
-
-
FREE MEMBER
NO Posting or PM's Allowed
I am near Dade City, which is a bit of a drive from the panhandle, but I can do it for you - while you wait. UPS is probably cheaper than driving down, and is one-day anywhere in Florida.
OlManDow