-
Legacy Member
No.1 butt stock on a No.4?
I prefer the slender and shorter grip area of the No.1 butt stock to that of the No.4 so I would like to put a no.1 butt on my no.4. Any unforeseen problems with this? has any one else done this?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
04-02-2013 12:03 PM
# ADS
Friends and Sponsors
-
Legacy Member
It looks very possible. I am looking at the two buttstocks and they appear to be almost alike . Maybe the No.1 stock needs a little bit of wood trimmed off to fit a No.4 receiver.
-
-
-
Legacy Member
Search Peter Laidlers past posts.
If I recall correctly, Peter has posted before about doing this in service.
Paul
Found it for you. Here is the link.
http://photos.imageevent.com/badgerd...%20Fitting.pdf
Last edited by paulseamus; 04-03-2013 at 07:41 AM.
-
Thank You to paulseamus For This Useful Post:
-
Legacy Member
Thank you paulseamus that was most helpful. I thought I had read all of Peter Laidlers posts on fitting wood work but I managed to miss that one.
-