-
Deceased August 5th, 2016
front sight very slightly canted
i think the only way this can happen is that if the barrel was screwed in a bit too much. its barely noticeable, probably less than a degree.i doubt it would have any effect at 200 yards but i don't know for sure. is there a spec on this sort of thing?
would correcting it affect headspace?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-30-2009 06:42 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Canted front sight
I seem to remember that Gus Fisher use to say it you could get to within 1 degree eight way that was good. When I index my barrels, I get them down to 0 degree difference.
-
-
FREE MEMBER
NO Posting or PM's Allowed
One degree or less is OK. 1/2 degree for NM rifles. This amount shouldn't effect the headspace.
Semper Fi...