-
Advisory Panel
Ross Sniper Clone
Looking through my odds and ends, I have enough parts to assemble a Mk. III rifle with cut back stock. Stripped receiver, cut stock, detached barrel, etc. So, no harm would be done to an intact rifle.
Have a Fecker external adjustment scope, probably 1930s vintage. Looks not unlike a Winchester A5.
Are there any good photos, or, better yet, drawings of the mount system used with the A5?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-01-2015 06:54 AM
# ADS
Friends and Sponsors
-
Contributing Member
There is a pretty good picture of Paddy Riel`s rifle in The Ross Rifle Story p. 282.
Also same rifle different picture p. 9 Clive Law`s With Out Warning. Hard to make out details in this pic, but there is a National Archives reference #.
Last edited by Ax.303; 03-01-2015 at 10:56 AM.
-
-
-
Advisory Panel
Thanks. Dug out my copy, and had a look.
-