Trigger Spring Tool

[rocky321]

How the heck do you use the L shaped trigger spring tool?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Denny779]

Here's a pretty good description.

Make Ready Forum – the Panteao Productions Bulletin Board

[ulflyer]

I took a TH to local hardware store and bought a short piece of copper tube that fit into the rear hole on the TH. Cut off a short piece, and several for my friends, and you have tools to spare for a couple bucks. It doesn't need a bend to easily work as it should.

Secondly, I put the spring in first, then the trigger. No twisting of the spring required. Use whichever method works best.

[emmagee1917]

Also make a trigger pin the same length as the trigger width. Use it to assemble the trigger , sear , and sear spring . Insert as a unit and use the real trigger pin to drive out the short one . Much easier than trying to assemble inside the housing.
Chris

[JimF4M1s (Deceased)]

Been doing that for 25 years. I kept jamming my finger tips.
Assemble with a short pin outside the housing, drop in place, push short pin out with the regular pin.
Faster and easier on my fingers.

[imarangemaster]

I use an empty 30 carbine shell casing for a trigger spring tool.