-
FREE MEMBER
NO Posting or PM's Allowed
Last edited by brugmanncues; 01-30-2017 at 06:48 PM.
-
01-30-2017 06:45 PM
# ADS
Friends and Sponsors
-
Contributing Member
Looks good to me.........you worry too much.
-
The Following 2 Members Say Thank You to muffett.2008 For This Useful Post:
-
-
EXACTLY as Muffer says. That is absolutely perfect. Stop worrying. And while we're here, who told you about this so called overturn figure. And another thing. Get rid of that .070" gauge. It is alien to any other weapon except the Vickers and the only reason we had it on that was because........ Look, bin that gauge!
-
The Following 2 Members Say Thank You to Peter Laidler For This Useful Post:
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks for the replys I read about the overturn figure here in the "Technical Articles/Research for Milsurp Collectors and Re-loaders" section....In the "1991 No.4 (All Marks) .303 Rifle Maintenance Instructions". It states: "Check the bolt head to ensure it does not overturn by more than 20 degrees when assembled to the bolt. The 20 degrees may be measured as 4.76mm (3/16”) from the left corner of the bolt head lug to the left corner of the bolt column."
That's why I asked in the OP. But if you say it's good to go...AWESOME, 1 less thing.