-
Legacy Member
SC 03A3
Just got this one. Been looking for a nice one for awhile. Even though it went through a rebuild it looks like it is all or mostly SC. Does anyone know what the cutout in the stock by the cutoff is for?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
08-06-2017 01:13 PM
# ADS
Friends and Sponsors
-
Legacy Member
Clearance for your finger to operate the cutoff
-
-
-
Legacy Member
Not that I know what that is for. If you look at the stock you will see a cut that runs left to right by the cutout for the mag cutoff.
-
-
Contributing Member
That's where they cleaned up the area where some of the stock splintered off. Nice job. The RA P stamp over the FJA stamp shows it was at Raritan Arsenal in NJ.
-
Thank You to Tom in N.J. For This Useful Post:
-
Legacy Member
Thanks Tom thats what I thought.
-
-
Legacy Member
Nice Rifle, it looks like you have a Remington trigger guard plate. p.s I am learning how to identify parts so i hope i am right.
Last edited by 1911Ron; 08-11-2017 at 04:57 PM.
Old guns, cast iron and other things to spend my money on!
-
-
Legacy Member
You are right. I forgot which was which when I bought the SC.
-
Thank You to Detroit-1 For This Useful Post: