M1 Carbine Trigger Group Disassembled and Labelled

[Amsdorf]

Hope some might find this of use, below the picture is a link to an old war department movie providing excellent detailed explanation of the function of the trigger group.

[JimF4M1s]

Maybe you should block out that copyright on the bottom.

[browningautorifle]

I think you will find some of that in stickies on this site.

[Amsdorf]

[/COLOR]

I think you will find some of that in stickies on this site.

Link please?

---------- Post added at 12:20 PM ---------- Previous post was at 12:18 PM ----------

Maybe you should block out that copyright on the bottom.

Why? I'm Paul T. McCain and it's my photo.

[JimF4M1s]

[/COLOR]


Link please?

---------- Post added at 12:20 PM ---------- Previous post was at 12:18 PM ----------




Why? I'm Paul T. McCain and it's my photo.

I guess that makes it OK then.

[frankderrico]

You forgot to lable the hammer and housing. Nice photo though.....Frank

[browningautorifle]

2x trigger pins. Anyway, the stickies are at the beginning of the applicable section in each case. The Carbine section doesn't have this one. Just the trigger group as a whole.

[Amsdorf]

Good catch, thanks. Funny, I did the labels again to use the correct nomenclature and left this off.

I'll fix it and load up a new version.

Let me know if you notice anything else.

I do not have the pin used to put it into the receiver on the M1, but I figured that might be considered part of the non-trigger group parts.

---------- Post added at 05:53 PM ---------- Previous post was at 05:49 PM ----------

OK, fixed the labelling and also adjusted the histogram on the digital image to make it "pop" a bit more. What do you think?

[Amsdorf]

I'd be honored if a forum owner deemed this worthy of "sticky" status.

[browningautorifle]

I was just going to say, can we move this over?