How to remove RLO from No.4 fore end?

[bow]

If the draws are unstable or rotten then cut out the draws and completely replace them (with epoxy soaked patches or not) as per Peter Laidlers articles: Milsurps Knowledge Library - Worn draws in your No1, 4 or 5 fore-end .... (by Peter Laidler)

Just done! Patched draws as per Peter instructions. After i did some mistakes on my previous 3 enfield, this time things went well. When i'll need to re-patch the draws i'm thinking to use stabilized wood. It's possible to stabilize quite well small piece of wood. Isn't it?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.