I have worked on the trigger mechanism, and bedding, of my No1 Mk3 Lee Enfield and the sear & trigger were very good (with minimal work required) but the sear pivot screw is a very tight fit and won't test-seat all the way. I think it should be replaced and maybe retap the housing thread.
Refitting the sear spring is also tricky ...is there an easy way? Any tricks?
The thread is very fine (not a BA or BSF thread) so any idea what it is?
Where can I buy these spare parts?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.