-
Member
BM62 question
Took my BM62 out to the range today, shot very well. Was wondering if it is an easy swap out to put a tri compensator on as I dont like the muzzle device currently on it. Any advice would be great!
-
-
12-28-2019 05:28 PM
# ADS
Friends and Sponsors
-
Member
Both muzzle devices will interchange on the BM59/62 rifles. There is also a shorter 5" compensator you can use also. Just harder to find.
StandardParts LLC has the tricompensators for sale if you are looking for one.
-
-
-
Member
Thanks man I think the 5 would look better than the tri compensator but if I cant find one of the shorter ones I'll just go that route. Also I got home to clean it and the gas nut was only finger tight. Would that have cause some of the accuracy issues I had at the range?
-
-
Member
Originally Posted by
Btl1994
Thanks man I think the 5 would look better than the tri compensator but if I cant find one of the shorter ones I'll just go that route. Also I got home to clean it and the gas nut was only finger tight. Would that have cause some of the accuracy issues I had at the range?
Don't know the issues you may have had but yes, with the gas lock nut being loose it could affect accuracy.
-
-
Member
Some rounds would be dead on and then I dont know if it's me or what they'd start going all over the paper. I feel some of it was me but I know some of it was that lose nut. I will be changing the muzzle device as the one on the 62s sucks!
-
-
Contributing Member
It should be no problem. The tricompensator is great!
34a cp., btg. Susa, 3° rgt. Alpini
-
-
Member
I have one on my Springfield BM59. It's never been fired so I'm gonna leave it that way and shoot my 62 instead.
-
-
Senior Member
The Tricompensator is the way to go. I had an SAI BM-59 (Serial 85x) back in the 1990's and was allowed to shoot Service Rifle with it at Fort Richardson - until some of the top shooters noticed I had NO Muzzle Rise during the rapid fire stages. The Range Officer didn't really care, but, under pressure, told me I had to bring an M1 or an M1A
from now on.
Try it, you'll like what it does - gun looks better, too. CC
-
-
Member
Standard Parts, Ltd has a gas lock that will allow you adapt almost any flash hider.
My 69 has a 3”, the tri comp just looked awkward on a 69
-
PM
