Hello!

My long journey to make my 1200TX as close to an M82 as possible continues, down to the screw!

I have gathered that the Parker Hale scope bases, #s 22 and 28 in the case of the 1200, used 2BA screw threads, however I am unsure of the correct length. It would likely be a trivial task to have them cut down, but I'd like to purchase the correct size(s) from the get-go.

Any guidance would be greatly appreciated!
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.