I've got a few more pictures of this "current" 408K Inland, so will post below. Somewhere, I've read that Inland may have used some unmarked Type 1 "bull-nose" hand guards in the Spring of '43 and I believe the milling pattern on this one is the same as one Charlie helped me with before. He figured it was made by Winchester, but neither one of us could see a "w" on it anywhere. What do you guys think? I attached one of the code in the stock channel, too - hard to make out but I think it reads: 126 1

I also wanted to show the trigger housing and the "hammer strikes" - even though they're hard to see, I think both are there. - Bob

Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.