Bolt Release lever or do you rotate the bolt head?

[Williamb]

I have a No 1 MK IV. Wondering how you remove the bolt. I don't see a bolt release lever as I have on the No 4 MK II. Was there suppose to be one? Or do you lift and pull the bolt to the rear and then rotate the bolt head counter clockwise?

If I'm missing the release lever how big of a deal is it to replace and is it an Ebay item?

Thanks for your help I'm completely in the dark on this one.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Amatikulu]

Did you mean to say No.4 Mark 1? If so, the fact that you are asking about a bolt release lever makes me think you have a No.4 mark 1*

If that is the case, the bolt is removed by drawing the bolt back until the bolt head lines up with a cut out in the bolt rail (right hand side of receiver). At that point you rotate the bolt head counter clockwise and the bolt can then be drawn rearwards and removed.

If its a No.1 mark 4, you have simply pull the bolt fully rearwards and then wit a bit of force rotate th bolthead counter clockwise and remove the bolt

[Williamb]

It is a No 1 MK IV. The reason I asked was that I could never rotate the bolt head - it is very stiff and therefore did not want to force it. Also it seems that the wood in this area has the same relief cut as my No. 4 MK II for the bolt release lever and this got me too wondering.

I'll use a bit of Kroil first.

Thanks

[bradtx]

Williamb, Sometimes it can be very difficult to rotate the bolthead on a No.1. My Lithgow requires two thumbs pushing upwards, not much easier with the Ishapore...watch your finger nails!

Brad

[Williamb]

Brad -

That's the deal. It is just very stiff. I will give it another try.

Thanks

[Edward Horton]

I was watching the history channel the other night and 3000 years ago even the Egyptians knew how to use levers to build the Pyramids

Close pin



Popsicle stick, if you just ate the ice cream use the dry end of the stick.



I teach this in my white collar survival class

[bradtx]

Ed, Any clothespins I may have had were turned into popcorn guns years ago! I'll have to try a bicycle tire tool.

Brad

[LithgowHT]

Try the right knuckle on your index finger right hand, saves your finger nails! and funnily enough is the listed military bolt removal procedure from decades ago.

[louthepou]

Try the right knuckle on your index finger right hand, saves your finger nails! and funnily enough is the listed military bolt removal procedure from decades ago.

I've seen a few SMLE's in which the bolt head was really difficult to rotate. Many times that was due to crud, sand, whatever, accumulated behind the springy "tab", thus preventing it from being pushed in by the bolt head trying to rotate. So I'D disassemble the rifle, remove the tab, clean all and reassemble... Often that did the trick.

Lou

[A square 10]

what am i missing here ? no1 mkIV ?

im assuming it to be a no1 mkIII* or a no2 mkIV , i realise neil knows his rifles and am guessing he just left this go ..........but , if not .............

and i see he used the nomenclature no1 mk4 in his reply - do i need to look for another rifle for my collection ? :>}