20 Inch M14/M1A Barrel

[The Wizard]

Does anyone make a standard contour 20 inch barrel for the M14/M1A? 18 inches a little too short / 22 inches a little too long for MY purpose/taste. I guess I could have a 22 inch barrel shortened. If I have to go that route any recommendation as to who should do the deed?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[AKA Hugh Uno]

any competent smithie should be able to do this. fulton or clint fowler or "chuckinDenver" (on the 03 forum) could easily do this. just send the barreled receiver (assuming your have a headspaced barrel already mounted). If not send receiver, barrel, bolt, flash-hider, voila.