My Gunshow AFourgery

[crazycossack]

I found the following at a gunshow, it had the Redfield base already installed. Its a two groove Remington barrel and Remington receiver.

Here are the before and after photos.

Attachment 30813Attachment 30806Attachment 30805Attachment 30808Attachment 30810Attachment 30811Attachment 30812

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[PeteDavis]

Bolt cutout? Here's mine

[PeteDavis]

Both of mine still have the front sights.

[crazycossack]

Minimum cut out for the bolt I got from OWS as compared to the original on my other one. I'll take a pic tomorrow.

Taking the front sight off isn't too hard. Soak it in PB blaster for about a week and drive out the pin with a short stout punch and then drive off the sight with a big hammer. Its strange the first one I did was parked underneath the FS the second wasn't