Hi all,
This may have been answered before but can't find where.
I am some measurements.
the brass tube on the front of the scope, and the dials.
I need all the measurements to make a repro set for my K3 weaver.
My idea is to make it as close as possible.

The tube will be simple enough to make and the dials I am going to make them screw on to the cap thread allready on the scope and then leave the centre open enough to allow access to the adjusters.
Don't know if it will work but if I can get the info I will try.

Cheers and thanks
NED
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.