I received a SG Winchester M1icon a few weeks back from CMPicon. I disassembled it yesterday and noticed that the hammer will not release when the trigger is pulled. I didn't try to snap it before I broke it down. It is a WRA trigger assembly and most of the parts look new.I was not planning on disassembling the trigger assembly since it looks clean and free of grease.
Should I try different parts or do some filing on the hammer and or sear? I can pull the hammer out, but it does not release on its own when the trigger is pulled; doesn't seem to be enough clearance.
Thanks,
Charles
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.