Ok, went to the range today tried my TT-33 with some new Sellier & Bellot 85grain FMJ and almost all, even trying with different clips failed to extract causing a second round to get jammed against the empty. Tried some Czechicon surplus corrosive and had no failures to extract. Extractor not broken could not see anything wrong with it. Anyone have any similar occurrences or any ideas? Also noticing that the primers on both corrosive and the non have a long impact by the firing pin almost like the brass is moving when the firing pin hits it, and does not create a perfectly round indentation.


Note: Not the original extractor, had extractor replaced a few weeks ago had a steel case stuck in the chamber that ripped a chunk of the extractor, could the new extractor be at fault? Have not tried Sellier & Bellot ammo with the original extractor.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.