Was doing a pre-"range trip" check on the Finn and noticed the rear sight base was quite "wiggly". Pulled the barrel bands and handguard off for further inspection and the whole rear sight assembly slid completely off it's dovetail. Never was a good fit, as the old solder only stuck where it was blobbed up.

Resolder due to the poor fit is likely to be a disaster. Also don't want to refinish the whole thing.

Am leaning towards "steel bed" epoxy compound to re-attach it, but before proceeding, does anyone have any other suggestions?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.