I have a fairly decent M24/47. I have no desire to "Bubba" it, but I wanted to scope it so I used a scout scope setup that replaces the rear sight ladder with a Picatinny rail. Works fine, and it can be returned to original configuration in a few minutes.

But ... I don't care for the straight bolt. Aesthetically, I prefer the look of the turned-down bolts on the M48s and K98s. Does anyone know if either an M48 or a K98icon bolt would fit an M24/47? (Subject, of course, to headspacing concerns -- I'm mostly concerned with the nominal length of the bolt.)

Thanks.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.