US Carbine stock and handguard finishes and finishing.

[USAFChief]

Following are my observations and comments for what they are worth:

"THE M-1 CARBINE A Revolution in Gun-Stocking" by Grafton H. Cook, II and Barbara W. Cook covers in exhaustive detail the story of the S.E. Overton Company (the O in the Inland IO stamping) which produced by far the greatest number of carbine stocks and handguards -- almost three million sets -- as the primary US Government sub-contractor during WW2. Most of their output was used by the Inland Division of General Motors Corporation in fulfilling their carbine contracts -- just about all Inland carbines have Overton stocks and handguards. There is a section devoted to the start to finish operations (accompanied by photographs) employed by Overton in producing stocks and handguards during WWII. Here is my description of the Operation relating to finishing:

Operation No. 37 Dip in oil

Stocks and handguards were finished by immersing in a vat of Raw linseed oil, draining on racks, allowing absorption of oil without wiping off surplus on surface - in order to facilitate better penetration of oil (eliminated wiping down operation and fire hazard of oil soaked wipers).

And here is an extract from Department of the Army FM 23-7:

"......... A light coat of Oil, linseed, raw, applied at intervals and well rubbed in, with the heel of the hand, will help to keep moisture
out .........."

The Army/Air force prescription was always to use oil, linseed, raw (well rubbed in by hand) to treat and preserve Carbine stocks and hand guards.

Raw linseed oil was procured through Supply Channels IAW WD Supply Catalog ORD 3 SNL K-1 (Items of cleaning, preserving and lubricating materials; recoil fluids, special oils and miscellaneous related items)

8010-221-0611
LINSEED OIL RAW (1 GAL CAN)
TT-L-00215 (81348)

Later: mil-spec A-A-379A LINSEED OIL RAW
ASTM D 234-82

From what I can ascertain, Production Stocks and Hand Guards were finished using 150 grit/180 grit sandpaper which facilitates thorough penetration of raw linseed oil and produces the typical somewhat dull surface appearance -- it seems to me that refinishing them using finer grit sandpaper will produce the glossier finish which seems to be the bane of those wishing to faithfully emulate the authentic looking USGI finish on their Carbines.

JP

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.