From Peter L's article, "and the similarly downward angle of the draws is 74 degrees*"

Im about to make a draws out of Engish Ash (best wood I have) so I will be cutting a block with an accurate chop saw.

Also normally the end grain faces the draws, but I think I read somewhere that for best results use a non grain face?

Has anyone done the copper block mod on a no4 aka the no1 mk3* for target work? I take it its not an as issued thing though?

Tempted to go that way....easy to shim until nicely tight.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.