No.4 (T) for $20 build thread

[jonh172]

your cheek rest appears modelled on the Australian No1MkIII(HT) version.

I think you are correct, this one sits much higher than my original and the bolt fouls on it. I intend to shape it or maybe find another.

---------- Post added at 09:52 AM ---------- Previous post was at 09:50 AM ----------

I'd get a new butt because shortening your to remove the rounded edges and pixx-poor fit will alter the geometry of the stock bolt and 'wrist' of the butt. If it has some historical connection with that rifle then save it, but otherwise, in my bit-part opinion, it's toast.

Ok will do. Too bad I cant use this one... But I agree, it already looks too thin and my idea would thin it further.

---------- Post added at 09:54 AM ---------- Previous post was at 09:52 AM ----------

Pics of how the cheek rest is fitted to my T just as I purchased it from a chap, scope covers are repro's as the originals were reduced to end caps only.

Very nice, and thanks!

I'll use this one I have on hand to follow also




---------- Post added at 09:55 AM ---------- Previous post was at 09:54 AM ----------

Cheek riser screws mailed. Ron(Canada)

you're the man!