My Carbine

[duggaboy]

this is an OK carbine and I want to know how it shoots?? hey Gunner, how and where did you get this carbine? thanks duggaboy

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Mikey51]

Hi Gunner, emmigee has it right. Here's a pic to show what he describes. There is no need at all for a weld in that place to make an M2. What is worth thinking about however ... I have seen Carbines from several places (especially Germany), where an old scope/ tap/drill hole, has been welded over in that place. Cheers, Mike. N.Z.

[gunner]

Hi Gunner, emmigee has it right. Here's a pic to show what he describes. There is no need at all for a weld in that place to make an M2. What is worth thinking about however ... I have seen Carbines from several places (especially Germany), where an old scope/ tap/drill hole, has been welded over in that place. Cheers, Mike. N.Z.

Hi Mike,

thanks for your opinion it seems that your right on it. But where should be the drill holes for the rear mount? There is only one point welded, maybe under the rear sight base?

Regards

Gunner

[gunner]

this is an OK carbine and I want to know how it shoots?? hey Gunner, how and where did you get this carbine? thanks duggaboy

Hi duggaboy,

thanks, the Carbine shoots really great! I ve shot it several times and if i do it of an sandbag i got 10 Round shotgroups between 2" and 2.5" at 100 yards. I have it from an guy from our Gun Club who has it purchased for the PPC1500 Carbine shootings but he wasn´t a good shooter with the Carbine so i bought it with a huge amount of reloading components for an very good price.

Regards

Gunner