Recrowning an SKS ? ?

[Chuckindenver]

likely a staged photo..tool doesnt match the work, no matter who did the work...the ones i posted were taken, and done by me, and done in a haste, no debur or clean up was done.
i counter sink all crowns, 90% of muzzle damage is at that area,, including the one pictured in the OP.
counter sink, debur, then lap if needed.
i for one, would love to see some of Ed,s work.. with all the smack talking...its a put up or shut up time.. show us hows its done..

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Edward Horton]

i for one, would love to see some of Ed,s work.. with all the smack talking...its a put up or shut up time.. show us hows its done..

"its a put up or shut up time"

It would NOT be done by a unsteady hand that couldn't rotate 360 degrees and leaves chatter marks with a RCBS deburring tool.............



This is NOT the way to recrown ANY barrel........



This is as crude as anyone should ever get with simple hand tools.............



The people in these forums deserve to get the best possible answers from knowledgeable people and not be shown something as crude as a cartridge case deburring tool used to recrown a barrel.