HRA stock question

[Marty Glazier]

When did HRA switch from 3/8 inch DAS to 1/2 inch DAS? I know this has been covered before but at 64,I sometimes suffer from CRS!!

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Joe W]

When did HRA switch from 3/8 inch DAS to 1/2 inch DAS? I know this has been covered before but at 64,I sometimes suffer from CRS!!

According to Wayne Bradford the 1/2 " DAS became predominate in the 5.60 range.

[Schiavo]

Pretty good website below for cartouches:

http://www.trfindley.com/pgsnstmpsm1.html

Scroll down to the HRA section and according to this website:

S/N 4,661,000 to 5,609,000
Department of Defense Acceptance Stamp, 3/8" by 3/8" on left side of stock. The other stamp used was the circle 'P' proof mark, without serifs.

__________________________________________________ _______

S/N 5,561,000 to end of production
Department of Defense Acceptance Stamp, 1/2" by 1/2" on left side of stock. The other stamp used was the circle 'P' proof mark, without serifs.


Hope that helps nail it down...