Sorry TBone, I was a bit slow, its an H barrel, which brings me back to my own to and fros about what bedding method would be best for the barrel end. My initial query here was about the proper fitting of the draws end of everything so its almost two questions in one. I have a fultons rifle with a stock barrel and the overstrap and 3 extra internal springs that appear to dampen barrel vibrations, and I like the mechanical set up of that, however whether thats ideal for an H barrel I'm not sure. I have asked here about H barrel bedding before and have some good advice there, I just need to go back and re read everyones comments and think it over. I'm looking at setting this rifle up as there's a shooting event being planned in feb I'd like to take part in. Be nice to settle down to some serious paper perforating.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.