NEA-15 PDW, CQB & Carbine

[NorthEasternArms]

Dave,
If the butt plate had an extended sleeve that fit over the buffer stub you'd have a wider range of possible supported cheek positions and no impact to the stock OAL collapsed.

Steve

Something that'd have the same effect as the riser on the SAGE EBR?



I think it's doable. It's a matter of meeting a price point. We'll look into it though. We're always open to suggestions on any of our projects.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Stevo]

Something that'd have the same effect as the riser on the SAGE EBR?

https://www.milsurps.com/images/impo...lcslggif-1.jpg

I think it's doable. It's a matter of meeting a price point. We'll look into it though. We're always open to suggestions on any of our projects.

Sort, but not above the stock rails, like the Sage.

Imagine, if you will, that in the picture below the buffer stub is not visible because the buttstock extends over it.