Smellie I thank you for the advice. I have repaired the stock to the best of my workmanship and it looks good. The firing pin is a thread on type and for some reason was not screwed in. My barrel looks to be one of the ones that the U.S. armorers set back two threads. For sights I am going to try and find some reciever mounted sights along the lines of the Canadaicon Tool and Specialty Co. that was posted a few days ago. The aperature on the back of my bolt is attached with by the looks of it solder. The aperature is actually a threaded piece of metal that would except about a 1/4 inch bolt. When you look the aperature your looking at an area about the size of a basketball by the end of barrel. What parts do I need to replace the magazine cuttoff and the pawl. I found magazine cuttoffs at numrichs but they only have the trigger and are sold out of the springs where could I find one of these.