Quote Originally Posted by Peter Laidlericon View Post
It was a bit like describing a spiral staircase without using your hands!!!!!!!!
Ahahahah I chiseled out a tiny scrap of wood just under the two small cuts made some years ago to fit the handguard ring, because i found (with talcum trick) that there was an unwanted contact between the ring and fore end. As TBone wrote there's a bit of free movement of the ring itself. But comprehensive bedding is the same: perfect bearing at the draws i patched last week, perfect bearing around trigger guard screw and past for half an inch. No contact at the reinforce and barrel sit to the left at the fore end tip. It should be a warped fore end, but not the worst. So i'm going to patch the reinforce and to chisel out some wood at fore end tip to make the barrel fit "in the groove".. are there other solutions?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.