7.62mm barrel question, possible L8?

[Peter Laidler]

Was it cut down by less than an inch if the bayonet lugs were still present? No doubt that it was a Charnwood conversion if what you say bears out

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[bigduke6]

Was it cut down by less than an inch if the bayonet lugs were still present? No doubt that it was a Charnwood conversion if what you say bears out

Peter,

Its full lengh barrel, same contour as a No4 .303, mag is an original 7.62mm (not a charnwood)