7.62 Garand bedding question

[TMB]

Hi guys! I'm new to Garand. I own a 7.62 m1 garand and i'm following NRA article about Garand accurizing. I ordered the fixture to maintain the barrel centered while epoxy is curing plus the horsehoe rod for tensioning trigger guard& safety. I suspect 30.06 and 7.62 stocks are quite different: what is the correct distance between stock front ferrule and barrel for 7.62 garand? I hope you understand what i mean. Apologize my poor english.
Thank you

Your english is better than mine. I have'nt done any accurizing but I have both a 7.62 that was shortened 1/2" & a 30-06 the only difference I can see is the length of the stock,rear handguard,barrel & op rod on 7.62 is 1/2" shorter. If you have a 7.62 that was'nt shortened it should be same as 30-06 I think. I'm new to working on my Garands also.