Original finish on Butt Plate?

[Mark W.]

The holes are already drilled in the stock. So I think I will buy a lag blot with the same size thread cut some vertical slots in the screw like a tap has and use it as a pilot to get the thread started.

I managed the biggest hurdle out of the way today. I managed to get my hobby work bench cleaned off. I admit its a little intimidating sitting there waiting for me to get on with it.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Bill Hollinger]

I managed the biggest hurdle out of the way today. I managed to get my hobby work bench cleaned off. I admit its a little intimidating sitting there waiting for me to get on with it.

Ha Ha Ha!!! Boy, do I know that feeling!

[Rick the Librarian]

Ha Ha Ha!!! Boy, do I know that feeling!

Amen to that!!