New Milling Machine

[tbonesmith]

badged to the importer or seller

That's the one! Taiwanese manufactured. I'll level it in the coming days and get a suitable vice, I'm thinking a 6" swiveling job.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[bigduke6]

That's the one! Taiwanese manufactured. I'll level it in the coming days and get a suitable vice, I'm thinking a 6" swiveling job.

It looks very similar to a model over here, some of them are an import but under the label of Warco, have heard good stuff about them, nearly got one myself but a Tom Senior come up for a very decent price, its a duel machine but was only kitted out for Horizontal.

[jmoore]

I'll level it in the coming days and get a suitable vice, I'm thinking a 6" swiveling job.

We have found that using a 4x4" timber on the front and on the back works wonders for a stable footprint. (It also usually reduces back strain!) The machine compresses the wood locally but then it acts as a good damping contact. Shim under the timber to suit your leveling requirements. This set-up also allows for easy movement of the machine when required as a pallet jack will run in between the timbers quite nicely.

As for good holding gear, Kurt vices are among the finest you can buy. (if they're available in Australia.) I have one 4" and three 6" Kurts currently for personal use. At work they hugely dominate as well, both for conventional and CNC use.