No 32 MKII scope adjustments

[Warren]

Purchase the adjusting tool from where you bought the scope and then buy the book mentioned above, or check on the net. The adjusting sequence is there someplace. Or, make your own tool
The windage should not be tight. If anything most of the repro's I have looked at, the windage adjustment is quit loose and I have had to correct the condition.
Just out of curiosity, what do you have the scope mounted on and how is it mounted?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[gunsmith63]

Purchase the adjusting tool from where you bought the scope and then buy the book mentioned above, or check on the net. The adjusting sequence is there someplace. Or, make your own tool
The windage should not be tight. If anything most of the repro's I have looked at, the windage adjustment is quit loose and I have had to correct the condition.
Just out of curiosity, what do you have the scope mounted on and how is it mounted?

It's going on a No 4Mk1. I'm using a mount and pads from Accumounts. Drilling and tapping the receiver isn't a problem, but from reading some of Peter's articles, it sounds like getting the adjustments correct is not for the faint hearted.
Will lossening the outer clamp ring allow the windage turret to turn easier?