7.62x39 Test-fire video

[WallyG.]

I have had some .303 barrels rebored and rechambered to 8mm by a gunsmith in Washington State... Beautiful work... not sure if the dimensional difference in the .303starting barrels will work with your receiver though. Might have to have them made new... originals are rare on the open market and quite coveted here in the US... I've been looking for a few years now... but I don't get out to the full auto events where they seem to hide.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Hal O'Peridol]

I have had some .303 barrels rebored and rechambered to 8mm by a gunsmith in Washington State... Beautiful work... not sure if the dimensional difference in the .303starting barrels will work with your receiver though. Might have to have them made new... originals are rare on the open market and quite coveted here in the US... I've been looking for a few years now... but I don't get out to the full auto events where they seem to hide.

Wally, who did the work? I'm sitting on a couple thou 8mm, would give me another option other than .303.

[WallyG.]

Contact Wayne York at:

About Us - Services

I think very highly of his work and first class customer service.

My geography is off a bit... but then I'm from Alabama - all them westurn states look/seem alike. My wife says its all of the grey hair.