Bolt on Eddystone 1917 wont chamber a round?

[goessb170677]

Im going to give a +1 on a .308 chamber adapter. I cycled some .308 snap caps through the gun and they seem to work just fine. Im not throwing in the towel to .308 fully yet.

On Tuesday, or maybe Thursday, im going to get a chamber cast at a gunsmith 10 minutes away from me just to be sure.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Patrick Chadwick]

Oh, I get it...you guys don't understand separated casing...

Duuhh?? Wassat??

Oh, do you mean something like this?

Attachment 54305

Actually Jim, if you read my post carefully, you will see that at no time did I disagree with you, but kept an open mind and said it could be either a case fragment or a Bubbaed rechambering, since I have experienced both. What I am really hoping for is that we all stop speculating until the original poster finally conducts the utterly simple test that I proposed and finds out which it is. And if it is a bit of casing, then I agree with you that he should get the proper tool - as shown above.

On Tuesday, or maybe Thursday, im going to get a chamber cast at a gunsmith 10 minutes away from me just to be sure.

If there is a case fragment (of which my photo shows a particularly nasty example) then the casting material will flow in and solidify in front of the fragment, making it impossible to get it out again without removing the action from the stock and melting it out! And if you drive it out, there will be a ring of casting material left between the front of the fragment and the start of the transition cone. I fear that you may be about to spend money to make matters worse.

If my deduction is wrong, then I am happy to be enlightened, but until then, please remember KISS, and make the simple test that I recommended.

[browningautorifle]

stop speculating until the original poster finally conducts the utterly simple test that I proposed

Agreed.