Finish on Kodak Mk1 32 Scope

[waco16]

Well..........

The stable mate to the Tom Senior Milling machine is an equally as versatile '50s Raglan Little John (British Built!!) Screw cutting Centre lathe, perfectly capable of cutting a 2 start thread

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[bigduke6]

Well..........

The stable mate to the Tom Senior Milling machine is an equally as versatile '50s Raglan Little John (British Built!!) Screw cutting Centre lathe, perfectly capable of cutting a 2 start thread

Is it the junior or senior model ? going by the pic looks like you have the milling head attachment, is this original or an after fit ? only ask as I,ve got the machine and been looking for the milling head and slotting tool for some time but the prices are a bit eye watering I nearly purchased another machine so I could get milling head but it was one of them " The buyer must move machine by tomorrow etc", have a heath robinson set up at present, but involves running 2 motors, the last one i seen they wanted over £600.

Forgot to say certainly looks like you spent some hours on the restoration and a nice job, I was lucky with mine as it was in good nick, slight mishap when I had to break suddenly and I heard a crash in the back of the van..... just the belt casing a bit err...... damaged.