Accuracy Problems With M1917

[Andrew1995]

I tried it in both the up and down... As far as the stock goes i cant get the barrel and action out.. Its a Remington stock so i don't know if its just a really tight fit or im just doing something wrong...I know you take out the screws and there's one going through the Upper band (where the bayonet stud is) but the stock just seems to be stuck there and can pull it lose. So i really cant inspect the stock and barrel.. When i put the screws back on i do tighten them down pretty well. When i got the rifle the sight was drifted to the left so before i took it shooting i drifted it back to center. After shooting i looked at the target and saw everything was hitting high right.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Andrew1995]

Here are some pictures i took of the target and of the bore... The target was shot at 50 yard bench resting.. I did fire two shot at this same target at 25 yard to see if that would help at all. I circled 3 holes with a red marker, i believe two of them were the ones shot at 25, as for witch 2 i really dont know. Attachment 61217Attachment 61218Attachment 61219Attachment 61220